Power Cord Installation
Orange Tree Trade provides three kinds of power cords to connect the cut LED rope light.
Please check the accessories carefully and install in the right way.
Method 1: Screw Type Power Cord
- Put the spiral nut with thread onto one end of the rope light.
- Insert the splice connector pin into the inner wires of the rope light.
- After the insertion is done, tighten the spiral nut.
- Connect the splice connector with the wire connector, then tighten the spiral nut.
(Caution: This way is only for indoor use.)
Method 2: Housing Clamp Power Cord
- Insert the connector pin into the rope light. The pin and the rope light must run straightly.
- Place the shrinkable tubing over the rope light.
- Connect the pin to the power cord.
- Apply sealant on the joint, and leave the sealant dry before continuing installation.
- Push the shrinkable tubing in the center of the joint and heat it up.
- Install the housing clamp and tighten all screws.
Method 3: PVC Type Power Cord
- Insert the connector pin into the rope light. The pin and the rope light must run straightly.
- Place the shrinkable tubing over the rope light.
- Apply sealant (around 1 inch long from the end of the rope light) on the rope light. Now push the rope light into the power supply so that the connector pin completely insert into the socket.
- Leave the sealant dry before continuing installation.
- Push half of the shrinkable tubing over the power supply connector and half over the rope light and heat it up.
Notice: Connectors and joints can only withstand a limited amount of mechanical pressure.
More LED rope light modification guides :
LED
Rope Light Cutting Mark
Cutting LED Rope Light
Power
Cord Installation
Splice Connector Installation
T Connector Installation
Cross
Connector Installation
Mounting Installation
Fuse
Replacement
Troubleshooting
|