Cut the LED rope light according to the cutting mark as indicated on the rope light.
Make sure that all split ends are cut at the given marking.
Use a pair of scissors or cutter to cut away the split ends.
Make sure that all split ends are cut away neatly; or else it will cause a short circuit.
Repair a defective section:
Cut the defective section at the cutting marks and rejoin the rope light by a splice connector.
Please refer to the OTT LED rope light modification guide.
End Cap installation
Cover the end of rope light with an appropriate end cap and seal with sealant and tie with a tie strap for insulation.
The other end of the rope light can be joined to a power cord.
